![]() On the repeater end I have the following: And, there's a DB25 male on the other end that plugs into the URI. There's a DB25 male connector that plugs into the Vertex VXR-7000. To: Re: URI Hook up for Yeasu VXR-7000 (Angeo and Kevin) ![]() Sent from my BlackBerry Smartphone on the Verizon 4G LTE Network (I DO appreciate the learning factor and it’s benefits, but it sure can be frustrating sometimes!) ![]() That could probably save folks a lot of hassle in trying to figure this stuff out for themselves. Might be an interesting idea to create a repository for radio and interface connection diagrams with the relevant configuration bits. but at least the Pi has the power to do the job. Since the initial setup of the repeater, I’ve attempted to use dsp mode with a Raspberry Pi 3 with a RIM Lite and a different radio at my QTH and it seems to work just fine. I know that the URI and the RIM Lite are different interfaces with different wiring diagrams, but the concept should be the same. ![]() This works correctly but of course, we’ll have to program the PL into the repeater itself. I then fell back to using COR from the repeater with carrierfrom=USBinvert in the nf file. We wanted to use dsp mode because we wanted to implement the PL tones through the Raspberry Pi 3 controller. In my case, I initially tried using dsp mode and could not get it working at all. I’m very interested in this thread because I recently attempted to get this working on a VXR-7000 with a RIM Lite from Scott Zimmerman.
0 Comments
Leave a Reply. |